Quatech WLNG-ET-DP500 Series Manual de usuario descargar pdf (Pagina 32)

Company Confidential Quatech, Inc.

32 Airborne CLI Reference Manual 100-8081-100

The Private network is the wired interface provided by the bridge. This interface includes

a DHCP server and supports dynamic and static IP address assignment. This means any

Ethernet client supporting DHCP can be connected to the wired interface without any

configuration changes. The private network host can communicate with the Airborne

Bridge using the bridges Ethernet IP address on the private network.

The Airborne Ethernet Bridge supports NAT Level 3 and as such provides the following

advantages over the more traditional bridge functionality:

 A single network IP address on the public network. This simplifies management

of the devices on the network.

 A single point of authentication. The Airborne device handles authentication for

the public network, this means a single point of contact for all security interaction,

simplifying deployment for the network.

 Zero security footprint on the private network host.

 Support for DHCP and static IP on the private network. This capability allows the

host to be shipped without any configuration changes.

 Port forwarding. Allows you to decide if web page, telnet or FTP access should

be forwarded to the private network or handled by the Airborne Bridge.

 Plug-n-Play. In most cases all that is required for full functionality is configuration

of the wireless interface for the target network. This can be done before

deployment to minimize deployment time and complexity.

9.1 Public Network Interface

The public network interface is the Airborne Bridge’s wireless port. This interface

must be configured to associate and authenticate with the target network. To

successfully configure this interface the following must be configured correctly:

Table 1 - Public Network Configuration

Command

Description

wl-ssid

This identifies the target network for the Ethernet bridge.

wl-dhcp

This defines whether or not the device will use DHCP or a

static IP address. This address will become the target

address for any devices on the network wanting to

communicate with the bridge or the device attached to

the wired interface.

If DHCP is not being used it is necessary to configure the

following parameters:

wl-ip

Module Static IP address

wl-gateway

Network gateway IP address

wl-dns1

Primary DNS server IP

address

wl-dns2

Secondary DNS server IP

address

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 119 120

Comentarios a estos manuales

Sin comentarios

Quatech WLNG-ET-DP500 Series Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Quatech WLNG-ET-DP500 Series