
2 – CLI Commands
100-8005-101G Airborne™ Product Family CLI Reference Guide Page 23
Quatech, Inc. Confidential
2.2.2 Wireless Configuration Commands
Command CLI Arguments Ln Description
wl-mac [aschex] L4* Configures the MAC address of the wireless interface. The input is
six bytes aschex. The address specified by the argument temporarily
overwrites the factory value when the Module starts up.
If the reset command is issued, the Module reverts to the factory-
set MAC address at startup.
USE WITH CAUTION. Set at the DPAC factory.
wl-mac-clone [0 | 1] L3* When set to 0, the Airborne™ will use its MAC address for
communications with the access point on the wireless interface.
When set to 1, the Airborne™ will use the MAC address of the first
device on the wired interface for communications on the wireless
interface.
Default is 0.
wl-type [string] L3* Configures the wireless interface operation type to participate in an
infrastructure or peer-to-peer network.
a = Infrastructure (AP) mode (default)
p = Peer-to-peer (Ad Hoc) mode
wl-chan [integer] L2* Configures the wireless interface Ad Hoc channel number.
The channel number is only applicable in Ad Hoc mode. Some
channels are restricted in certain countries. OEMs must use only
unrestricted channels.
Channel range is 1 – 14.
Default is 1.
wl-ssid [string] L3* Applies the SSID used for 802.11 association.
Up to 31 characters. In Infrastructure mode, the SSID controls which
AP the Module connects to and affects the Module’s roaming
behavior. In Ad Hoc mode, the SSID defines the network name for
the Ad Hoc devices. Only the devices with the same SSIDs can
connect to each other.
any = The Module associates with the AP that has
the best signal quality, regardless of the AP’s
WEP, DHCP, authentication, or other
capabilities. Roaming is not supported.
(default)
<other-value> = The Module associates with the AP matching
the SSID that has the best signal quality.
Roaming is supported.
Comentarios a estos manuales