
12
z.one ultra and z.one ultra sp OPERATOR MANUAL 12-5
NOTE: Due to its physical size, the Sony UP-D25MD printer is not mountable
within the chassis of the
SmartCart/SmartCart sp. The printer requires only a
power and USB cable (no mounting hardware).
To Set Up
1. Attach AC power cable and USB print cable to the back of the UP-D25MD
printer.
2. Connect AC power cable to an open receptacle in the room.
3. Connect the USB data cable between the USB port on the Sony UP-D25MD
printer and any of the USB ports at the rear of the
SmartCart/SmartCart sp.
To Operate
1. Power on Sony UP-D25MD color printer.
2. Power on SmartCart/SmartCart sp.
3. Acquire desired ultrasound image on the system.
4. Press Freeze button.
5. Depending upon Store/Print button configuration, press appropriate button
(Store1 or Print) to trigger a print of the current onscreen image to the Sony
UP-D25MD color printer. (See
“Setting Up or Adding a Local (USB) Printer”
below.)
NOTE: If the Store/Print button configuration page is setup in Exam Completed
mode (see
“To Configure Store/Print Button” on page 11-8), you must press the
End Exam key to complete the current study before the printed image(s) will be
sent to the Sony UP-D25MD printer.
Setting Up or Adding a Local (USB) Printer
To Set Up or Add a Local USB Printer
1. Access the Printer screen:
Setup | System Setup | Archive | DICOM | Printers | New
2. The Printer screen displays.
Comentarios a estos manuales