Quatech Audio/Video Capture USB 2.0 Especificaciones descargar pdf (Pagina 58)

This page intentionally blank

CAUTION: If password protection (Access Control) is used, make sure

user-assigned passwords are retained in a safe place by the System

Administrator. If a password is lost or forgotten, no master password is available

for recovering access to the

SmartCart/SmartCart sp for normal operation. A

complete reinstallation of system software will be required.

Barcode Reader (Option)

 To Configure Barcode Reader

1. Go to Setup | System Setup | Display | Barcode. The Barcode Reader

Configuration screen displays.

Figure 3-13. Barcode Reader Configuration Screen

NOTE: The barcode you scan will populate only the field in you select above:

Patient ID or Accession on the Patient Information screen (

Figure 7-1 on

page 7-1). To change your selection, return to the Barcode Reader

Configuration screen.

IMPORTANT: You can use an approved barcode reader without configuring it on

the Barcode Reader Configuration screen. Instead, plug the barcode reader

into a USB port and open a Patient Information form (Figure 7-1 on page 7-1).

Place the cursor in any

field, then scan a barcode, and the barcode will display in

that field. You are not limited to the Patient ID or Accession fields.

Using the

Barcode

Reader

 New Patient or Exam

1. Plug barcode reader into a USB port on the system.

2. If barcode reader has not been configured on the system, the Barcode

Reader Configuration screen displays. See

Figure 3-13 for instructions to

configure your reader. Click Apply to save your settings.

Select Patient ID or Accession from

drop-down list; see note below

Select your Barcode Reader

from drop-down list. List shows

all approved readers for z.one

systems.

Default =

None. Select Worklist

Cache if you have applicable

DICOM worklist

Click Apply to save configuration

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 403 404

Sin comentarios

Quatech Audio/Video Capture USB 2.0 Especificaciones Pagina 58