Quatech Audio/Video Capture USB 2.0 Especificaciones descargar pdf (Pagina 359)

z.one ultra and z.one ultra sp OPERATOR MANUAL 14-17



Install media detected. Do you wish to install new software: Yes/No

5. To begin the software installation, press the Select button on the Scan Engine

for each of the two (2) dialog boxes that are sequentially displayed.

NOTE: If the software revision of the removable media is the same as the current

version and you want to cancel, select No. If you want to cancel for any other

reason, press the Back key and then manually remove the removable media.

6. The software install process is as follows:

• System license verification

• Software file transfer (download)

• Software validation

The complete software downloading sequence will take approximately 5

minutes.

7. At the completion of successful software installation, a dialog box displays on

the LCD screen, instructing the user to remove the removable media and

press any key to reboot.

• Remove the removable media from the SmartCart/SmartCart sp.

• Press any key on the System to reboot and begin normal operation.

Basic System Care

SmartCart/

SmartCart sp

Backup ZPak

Battery

(optional)

The SmartCart/SmartCart sp may be ordered with an optional ZPak battery that

can power the

SmartCart/SmartCart sp for up to 3 hours on a full charge. The

battery will allow the entire

SmartCart/SmartCart sp to be operated in normal use

without connection to AC power.

The battery is mounted at the base of the SmartCart/SmartCart sp and is

automatically kept charged from the DC power supplies within the System. The

battery is charged (as needed) whenever the

SmartCart/SmartCart sp is

connected to AC power.

Checking the

Battery (Scan

Engine)

The Scan Engine contains a rechargeable battery. The charge on this battery is

automatically maintained if the

Scan Engine is docked on a SmartCart/SmartCart

that remains connected to an active power receptacle with the circuit breaker

(located at the rear of the

SmartCart/SmartCart sp) in the ON position.

u To Check the Battery

1. Ensure that the SmartCart/SmartCart sp has been connected to an active

power receptacle for at least 4 hours with the

Scan Engine docked.

NOTE: Scanning during the battery charge will increase the amount of time for

charging.

2. Remove the Scan Engine from the SmartCart/SmartCart sp. If a transducer is

installed, remove it and store properly.

1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 403 404

Comentarios a estos manuales

Sin comentarios

Quatech Audio/Video Capture USB 2.0 Especificaciones Pagina 359

Comentarios a estos manuales